StimPlan在压裂模拟运行时,模拟结果显示总是达不到最终状态,只显示到达边界时间时的裂缝形态(本来设置泵注程序97分钟,但只模拟到19分钟)。如下图所示。请问如何解决?
racture exceeded the TOP of the grid at 1420.66 m,
at a time of 0.6 min
out of a planned pump time of 100.5 min.
Please raise the top of the Frac Grid in the E-StimPlan
Control Input in the Well Input Dialog.
---------------------------------------------------
The Simulation was STOPPED because the fracture exceeded
the maximum expected lateral length of 292.61 m
at a pump time of 19.9 min
out of a planned pump time of 100.5 min.
Please INCREASE the Maximum Expected 1/2 Length in the E-StimPlan
Control Input in the Well Data Input Dialog.
---------------------------------------------------
The CPU Time for this calculation was 0.05 minutes.
---------------------------------------------------