转换斜坡相关文献
渤海湾地区构造变换带及油气意义
利用地震剖面解释结果和构造编图成果,分析了渤海湾地区构造变换带的特征及其油气意义。渤海湾地区主要发育区域横向调节带和局部变换带两类构造变换带。区域横向调节带由北西向大型走滑断裂带组成,这些断裂带同时也...
余一欣 周心怀 魏刚 汤良杰 徐长贵 《古地理学报》2008年 第5期相关文献
东濮凹陷黄河南地区转换斜坡与油气勘探的关系
从转换斜坡的成因分析出发,深入研究了转换斜坡对油气的控制作用,认为转换斜坡局部应力场复杂多变,大量走向多变的交级小断层相互切割形成许多断块圈闭,半地堑中油气沿转换斜坡上倾方向运移时,可以在其中聚集成藏.
高文龙 杨惠裕 吴应汀 马昌球 曹开松 《内蒙古石油化工》2008年 第7期相关文献
1 转换斜坡及其成因
1. 1 转换斜坡
转换斜坡又称走向斜坡、断层转换带, 发育于雁列断层系中两条相邻断层的相互重叠部分(叠覆段) , 连接着一条断层的上盘和另一断层的下盘, 通过变形和重定向使得叠覆段地层在不同断层的上下盘保持连续。
1. 2 转换斜坡的成因
转换斜坡的形成与叠覆断层系的分段演化有关。一般认为边界下断层演化有两种模式, 一是简单正断层模式, 即边界断层由一条正断层逐渐生长发展而成, 断层遵守长度- 位移比例关系; 二是多条断层早期分别演化, 后期形成统一的断层系。后者的演化可分为3 个阶段(图1):
①不共线孤立断层阶段: 各断层在平面上有一定间距, 各自独立演化, 基本特征也是断层中部位移最大, 向两端逐渐减小, 各自在其上盘控制一个横向向斜(半地堑)。
②叠覆阶段: 各断层沿走向发育发生叠覆, 断层之间相互作用, 但没有明显连接, 表现出分段活动的特征。应变在叠覆段的断层之间重新分配, 位移的转移主要通过转换斜坡上产生传递断层和地层变形来实现, 断层系上盘形成一系列向斜和背斜。
③连锁阶段: 最终各断层将发生连锁, 遵守长度- 位移比例关系形成统一的断层系统, 转换斜被破坏, 其对应的上盘横向背斜将沉降, 在断层系上盘形成一个统一的向斜。
伸展域构造变换带内部构造类型研究
分别从传递带和调节带两个方面论述了构造变换带内的构造类型,将传递带内的构造类型分为传递断层等四种类型,将调节带内的构造类型划分为背斜等四种类型。分析了传递带与调节带内各构造类型的发育条件、几何形态特征...
李学艳 王秀娟 侯加根 《中国煤田地质》2005年 第2期相关文献
当两条叠覆的边界断层走向近于平行,倾向一致时,受到这两条边界断层各自上下盘的垂直升降运动,在叠覆地带常形成转换斜坡.
东濮凹陷长垣断层系中转换斜坡的特征与油气勘探
东濮凹陷西部长垣断层系为由5条断层首尾相互叠覆组成的雁列状断层系,断层叠覆段发育转换斜坡。转换斜坡连接一条断层的上盘和另一断层的下盘,具有特殊的变形特征,在转换斜坡近旁的断层系上盘伴生横向背斜。叠覆断...
孙思敏 汪新文 《石油勘探与开发》2003年 第1期相关文献
Sandbox models of relay ramp structure and evolution
R. Husa,*, V. Acocellab, R. Funiciellob, M. De Batista
Relay ramps are common in normal fault systems. They consist of an area of reoriented bedding between two normal faults that overlap in map view and have the same dip direction (Fig. 1; Peacock et al., 2000a). The reorientation or tilt of the bedding is the result of the decrease in displacement at the fault tips.
Active relay ramps and normal fault propagation on Kilauea Volcano,Hawaii
D.C.P.Peacock*,1,E.A.Par?tt
Journal of Structural Geology 24(2002)729±742
A relay ramp(Fig.1)is a volume of rotation between two normal fault segments that overstep along strike and that have the same dip direction(Goguel,1952; Larsen,1988).Macdonald(1957)calls these structures monoclinal ramps.Peacock et al.(2000)give other synonymous terms.Relay ramps are very common in normal fault systems,and they can be important foci for hydrocarbon migration(Larsen,1988;Morley et al.,1990;Peacock and Sanderson,1994,their?g.16). A relay ramp connects the footwall with the hanging wall of a fault system,and transfers displacement between the overstepping segments(Peacock and Sanderson,1991,1994).Displacement transfer by relay ramps is accompanied by steep displacement gradients along fault segments at oversteps.Relay ramps typically contribute to a local minimum in total fault displacement at a linkage point(Peacock and Sanderson,1991,1994;Schlische,1992).Networks of faults can occur in a relay ramp to accommodate the dipping of beds(e.g.Grif?ths,1980).